I got to talk with Henry Portz a few days ago about my trans oil pump. He suggested a bronze bushing will work ok. I know he was rebuilding these oil or as some called them, grease pumps. He made a few modifications so they were pumping something like 25% more fluid thru the trans. I feel I can make those improvements but not sure if it has any long term benifits. More research needed.
Yesterday I purchased 13 inches of 932 bronze tube for the making of second, third and forth gear bushings. The material is called a tube and the OD is 2 in and the ID is 1 3/4 in. I plan a 1 1/2 thousands interference fit.I may freeze the bushing and warm up the gear to about 150 degrees. I know not to warm the gear higher than 250 degrees and NEVER see any bluing from the heat either. The material purchased from Mcmaster carr is part number 8911K313 Cost was $42.25 plus tax. Really easy to machine too. Am waiting on one gear so I can cut in half the .0042 cut per revolutions of the work piece in my lathe. Its a 12 inch Craftsman lathe and they are notorious for not running slow enough to make a fine finish cut. That will be fixed by this weekend.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
