Hi Jonathan. When I initially tightened my axle nuts I used a 3/4" drive ratchet with a two ft long pipe slipped over the handle. The total leverage was about three feet with the ratchet head supported on wooden blocks to keep the socket inline with the axle nut. Brute force was gradually applied until I figured it was enough. Later I was able to borrow a 1000 ft lb tension wrench and check the nuts at the required 300 ft lb. Surprisingly I was very close but a little under the mark.
A 1000 ft lb tension wrench is a bout 4 ft long and is quite heavy. At least I was able to get a check on my approximation which should be close enough for others.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
