Here are some pics of the taken apart passenger side door lock. In one pic of the bumbler cylinder you can see the brass lip that sticks up at the bottom. That is the piece you need to press down thru the hole in the body. A piece of bailing wire makes a good pin and fits well. You can bend it to fit your hand as I did. Looking down into the lock from the outside you can see how the lock cylinder must fit into the pin and the round hole in the lock piece. That square piece is something I think slides and locks the door. It has to fit into a small pin coming out the bottom of the cylinder. Mine never worked and was found broken off. See how the bevel is attached to the shaft by the pressed up metal. I ground that off so everything slid off the end of the square shaft. Then there is the clips that holds all this to the door skin. I pressed them out from the inside with a screwdriver. It took some force too. I understand if they are missing or rusted away any GM doord clip works fine. I recall someone posting about this some years ago. Mine are intack and working fine. Enjoy and please ask questions. I may be able to answer them but not an expert on anything.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.








