Just give it a good yank. The balls will then fly all over the place. Clean thoroughly. If balls have any cracks or corrosion, replace them. Wash everything in soap and water, and dry thoroughly. When putting back together, use marine quality grease I.e. Water resistant and will not break down with heat. One full tube per c/v joint. It's a two person operation: one to hold the whole assembly together and turns it and rotates it, while the other fills every nook and cranny with grease until the tube empties.
Tim.
Tim
 
I have a set of Richardson joints on our 810 which Lee made up from Tornado units. Some years ago I had to pull one joint and install a new boot. The boot kit, which was for a Tornado, came with grease which I used . It has been at least 6,000 miles and all is well. I don't know what the difference and benefit is between running your marine grease and the grease that came with my boot kit. It could be you are running original joints ,which I aren't sealed too well, and the Tornado which I think are seal much better. Is this your thought?
Don't know why they won't come apart. On my originals, we had to be very careful and hold them together during the reassembly into the frame. Seemed like they would just come apart at the weirdest times. Yours appear to be in really good shape I.e. No sign of wear in the grooves.
Yes, I am using original equipment. So far, so good. 13,000 miles and counting. On this last redo ( because of leakage), we made darned sure that the seals, gaskets, and fit were making good seal with proper spacing and tightening of the large brass ring. Just incidental grease appearing from time to time.
Maybe just clean yours really well, and reinstall with new grease. I think your grease will work just as well as mine.
T.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.



