Looks to be a stiffener as you suggest. The welds look very professional. It seems as though the welds would have distorted the rails, thus negating any better seal. I think the angle iron was welded in place and then the holes drilled with the orig. holes as guides. Maybe the person doing the job didn't realize how close the holes would be until they were drilled.
Cordially Mike
Well I finally got both sides of the angle iron removed from the oil pan rails. I was able to use a die grinder on one side to cut off all of it but.. The dip stick side had plenty of issues requiring some oxy acetylene torch work. I used a 000 new cutting tip for th difficult areas under the dip stick tube. I'm very good with a cutting torch and on thin metal like this. There are some tricks to scarfing off material. The small air gap between the piece you are cutting off keeps the metal you want to save from being cut. But care must be used not to warm up the actual pan material. Because I had already made deep cuts thru the weld I was easily able to scarf off the angle iron and not damage the oil pan rail. Hope the pics come thru. I'm now using Mozilla firefox so we will see if its better than chrome.
Very nice job!
Cordially Mike
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.









