17
@1748 S
Replies (5)
M
Hi, If you are referring to the bushings on the inside of 2,3,4th they must be made to size and custom fit the sleeve shaft. Sleeve must be chromed and ground to specs.
M
Yes those are the gear bushings I was asking about. There is also a small bushing in the small cluster named 1st reverse. That is the only gear piece that can be removed with the engine and trans in the car.
Can anyone recommend a material specifically fit for these parts? Thanks for all this tremendous help. Without it I sure would be doing things wrong.
My plan was to hard chrome the shaft in those 3 locations pictured in the Ayers trans book.
M
I have had mixed results with hard chrome. Be sure you are using a shop with a good reputation!
Cordially Mike
M
I am NOT a Cord tdransmission expert but the three transmissions I have rebuilt these using a bushing made from a bronze bearing stock. I got mine from McMaster Carr, it is a part number #8911K313 Multipurpose 932 bronze bearing tube 2" OD x 1-3/4" ID. My machine shop machined the bearings from this material, and cut diaganol grooves similar to original. George, Lee, Henry, and Jim and others may have their suggestions. I have not hard chromed any shafts, but have selected shafts that have minimal wear. General I found most shaft have little wear since the gears have a softer bronze bushing for wear.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
