I have seen a screen placed in the rectangular hole. What was used was a copper screen made with copper wire larger than what is used in screen doors. The piece of screen being used is larger than hole so the screen is shaped to fit into the back side of the hole (or inside the transmission). If you wanted to be sure the screen stayed in place it could be tack weld in place or ?
 
What is another good item to install are drain plugs with magnets attached to them. You used to get these at auto part stores for use on flat head Ford transmissions. Today you probably will need to go to a hot rod shop or shop on line. One of the drain plug would be located in front of the rectangular oil pickup hole where the screen is installed, the other drain plug would be for the differential. I have these drain plugs in my transmission.
Thanks Tom for all this great information. Earlier today I called Henry and he told me the same as you have but added reasons. So I thought a pic with some gauge needle paint might help others reading this. Pics do wonders if they are focused and clearly showing the topic. So a little grey paint for high lights and some red arrows and such hopefully helps. So the top hole is where the line has the pictured plug forced into the passage way shown with the dotted red line. If that plug is not there the pressurized oil will not go thru the filter. BTW Henry told me this is how this oil pump was originally set up. It did not have a filter so it went directly to the top main shaft. See at the very bottom of the trans next to the rectangle port. That is the pump pickup. A screen is a good idea in there because of the trans grinding up the gears and such will enter the pump and destroy the gears. Henry said he found all the springs and snychro balls lined up in the pump oil passage once so as you have suggested a magnetic drain plug is a great idea under the trans. I have that now and have had it for years. The red dotted line is the new direction Cord decided to run the oil out the bottom brass port and into the filter. The port with the two red arrows is where the pressurized oil leaves the pump and then out the brass fitting. Then it comes back to the front of the shifting housing and the main shaft. Inside the shift housing is a thin metal cap that really should be removed and cleaned out. I checked mine and think I cleaned that out way back in the early 1980's. Sadly I do not recall much of what happened in another century. I just hope I had lots of fun.. :wink:
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.


