Hi Tim, I have 3 cases marked on the side.T 238 and T508 marked on left (drivers) side. The 3rd case is odd, marked T 1577 on top where the S/N is located on the later cases. This is also a type 1 case with the external retaining bolt for the idler shaft. After cleaning the case I found another S/N marked on the right side, not the left, it is T150. Also, followed by a 2 inch space the numbers, 100- 09. These last numbers were stamped in using a smaller stamp. Maybe a factory rebuild and also renumbered? Any ideas?
Eric
Hi Eric.
 
Could you either post or send me some photos of the numbers on the cases you are talking about.
 
Most of the transmission cases were marked on the top as noted in the posts above. There were some early cases that were on the left side. I've never seen or heard of them being stamped on the right side, but then again we are still learning about these cars.
 
Thanks,
Jim
Hi Eric: I will forward your numbers info to Ron Irwin, the Cord historian. He does not use the Internet. Perhaps he can provide more info. As Jim O'Brien says, we are still learning.
CORDially, Tim.
Jim Arneson (posting photos for Eric J)...
 
First: Transmission case marked T1577 on top and T150 on the side (3 photos).
 
See all the photos here... http://jwpictures.smugmug.com/Cars/Engi ... ion-Cases/
 
 
 
Jim Arneson for Eric J...
 
Second: Transmission case marked T238.
 
 
Jim Arneson for Eric J
 
Third: Transmission case marked T508
 
 
Jim,
I thought all S/N's were stamped on top like the first photo T1577.
I don't believe I ever recorded the number on the side
 
Joel
Joel,
 
Almost all S/N's were stamped on the top as we are used to seeing. There are some that were stamped on the left side like T508 and T238 above. These are very few, I only remember one in Certification.
 
I have never seen the stamping on the right side as shown above. That is where I need to do some additional research and try to figure it out. The photos here are very helpful.
 
Jim
It is better to use right and left side. There are right hand drive cars and using driver and passenger can be very confusing.
Cordially Mike
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
