17
@1748 S
Gary, when I put up this question in 2010 I did not get much of a response.
 
http://forums.phpstack-1081784-3880776.cloudwaysapps.com/phpbb2/viewto ... ght=#18832
 
In the end I drilled both the nut and shaft for lock wire.
Hope this helps
Frank
Gary, to be honest I don't remember where I got the torque figure from.
I don't think it matters if it's 120 or 170. The bearings need to be shimmed and the nut needs to be tight. When new
the collar should probably have been enough to shim out the bearings, but after all these years....
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.