My cam and rockers are finally out on the bench and bagged and tagged. Found some bearing issues. Seems 2 bearings spun in the block because the clearance was too tight on the cam. So I need a set of cam bearings. Are their ant other bearings that fit the Cord?
Now for the how its done. I had no idea which end the cam comes out from. Of course I went the wrong way by attempting to pull it out from the water pump end. Can't happen because the bearing journels are smaller towards that end of the cam. There are 5 bearings on the cam but only three on the crank. Go figure that one. Getting the cam out the flywheel end is no problem because the clearances of the bearings to journels is getting bigger as you withdraw the cam. I found it easier to remove the rocker shafts only enough to remove one rocker at a time. I took pics because of the shims, springs and spacers found. All that was in new condition because this was rebuilt in 1961 by some shop. I have no idea who did it. Everything was ground and it new condition. New roller rockers and ground new valves and adjusters. My cam bearings are not the babbit type but the aftermarket type that looks like brass. Not the clad babbit material. I have not measured the bearing to block interferiance fit yet on the spun bearings. I'm not too woriied bout those journells being opened up because the bearing spun like is found when a main spins in a gas engine. It usually ruins the block. I have not removed the tube that supplys oil to the cam bearings or the timing chain yet. I may not remove it. I really do not think its ever been removed. Now back to the cam removel. The oil pump drive shaft has to be removed before the cam can get out because of the rocker shaft and the diameter of the gear hitting the cam bearing. Thats the tricky spot. There is a tiny little straight blade screw drive slot in a small threaded ste screw back just about and to the right of the drivers side rocker shaft square plug. Probably be best to clean off that end of the block because its nearly impossible to see. Mine was tight. I ended up using and hammer impact and some heat and aerokroil soaking. It finally came loose. Boy was it long too. Once that is out just drive out the shaft from the bottom of the engine block. I made up a soft landing for it when it came out. A third hand would be nice to have in this instance. I'm going to need some demensions on the bearing journels. I miced all of them and need to know what the block bore size is for the bearings and the cam bearing to block beaing fit is.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
