The angle on the intakes valves are 30 degrees and the exhausts valves are 45 degrees.
 
When I removed the rust from my block I used a very long common screw driver with a narrow blade and a magnet on a long flexible shaft. I used the screw driver to break the rust loose and the magnet to remove the rust from the block. It took quite a while but I think I got everything. I kept the rust that I got out and weigh it. It was over 5 pounds. After that I had the block soaked at an engine shop. Probably should have had it soaked before I scrapped it. Anyway, I don't have a heating problems as it never gets over 180 degrees. I put screens in the top water inlets of the radiator to catch anything that comes. Check the screens but not much there.