New Departure 916. You will find them on ebay from time to time. this bearing was also used by Buick and Cadillac, so make sure you search ebay listings for all of these applications. If my memory is correct, the GM part number has additional prefix numbers but ends in 916.
 
Sorry, I am not familiar with the bearing that Stan sells for this application.
 
Cordially, Mike
The 1941 Chilton Flat Rate & Service Manual shows it as 900916 "jnter arm bearing", for
Cord '36, '37
Lasalle '35, '36 50 series
Olds '36, L and F series
Cadillac '36 60 series.
 
The 1941 price was a whopping $3, except that for the Cord it is described under the same number as
"Inter steering arm", price $9.20
No Buick application found.
It is possible 1940- 41 Hudson used this 916 ND bearing, as I remember
a customer having lost the center bolt while driving but managed to stop in time. Driver walked back and found the bolt on the road !
 
George.
Hi,
 
I installed my wishbone bolt with a nylon-locking nut, as per Josh Malks' advice.
 
My wishbone bearing appears to be in good shape, and I have a used bearing of unknown quality. However, I have to ask, could not a bronze bushing be used in lieu of this bearing? It'd be easy to machine, easy to lubricate via the zerk, and presumably solid enough to do the job.
 
Ditto for the trailing arm needle bearings?
 
Any engineers in the forum who could address this?
 
--Tom
I'm no engineer but I think if they could have gotten away with a bushing instead of a bearing they would have. A bushing is much cheaper than a bearing.
Cordially Mike
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
