What pins are you talking about? The pins that hold the inner and outter CV joints together? If that's the case when you put it back together use a roll pin instead of the drive pins. It holds just fine and a lot easier to get out.
M
· Nov 23, 2014
Jim its the pins that holds the steel shell to the dog bone side of the universal joint. I got it figured out. I was using a sharpened flat blade screw driver but was getting lots of flex. Ended up using an endustrical scraper I made up probably 20 years ago. All the scraper is was a broken power hacksaw blade sharpened on one end. Surprisingly they have a hardened dege where the teeth are but the rest of the blade is softer material. This blade was about 24 inches x 2 inches x 1/8 inch. A couple of 1/4 inch cork gasket material glued to the handle and some electrical tape makes for a nice handle. Leaving the end clear makes for a very positive hit directing thru to the work being done. Thanks for the tip on the roll pins. Thats a good idea. I'm sure these joints have never been apart since they were made some 75+ years back.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.