Gary,
 
There isn't a shop manual for these engines. The clearances are what is standards for babbited bearings. .005 clearance is too much, if I remember right you should be down in .0015" to .002" range on the mains.
 
On the pins, if the bottom half can't move neither can the top. So you only really need to pin one side.
 
Jim
How are you measuring the clearance? Jim is right .005 is toooo much!
Cordially Mike
I just got some running clearances from Stan Gilliand. As for the rods what he sent me was this.
Rod journel ...........2.00 standard
Journel length .......2.125
Clearance .............0.001 to 0.0025 (0.001 best for us)
I sent you a pm offering all the other clearances.
Gary,
 
I wouldn't machine the end caps. .003" is a lot to take off and will result in the hole becoming egg shaped.
 
Jim
Gary,
 
The engine oil filter would be a deduction since the car didn't come that way. The deduction would only be for authenticity as long as it's done "in a workmanship like manor." The Safety items like seat belts and sealed beams are not a deduction but they are taking into consideration for best of Class and Best of Show judging.
 
For my two cents - my car will have a full flow oil filter on it since I plan on driving the daylights out of it. 🙂
 
Jim
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
