Well so far all those that have viewed this post have no comments. Makes me wonder why so much interest in a post but no comments. But thats no problem.
So far I have gotten most of the starter apart. Its really been an adventure in early mechanical invention to say the least. Appears 2 of the brushes are soldiered to the coils and the other 2 are screwed in. Interesting idea. I may remove the coils and use a soldering iron from early last century because it has a large heat sink on it. My other is more inline for small wire repairs. So after the brushe end is off the rotor has to be either pressed out or driven out of the body of the starter from the cone end. If a starter has been rusted up or been in a slat belt area all I can say is go slow and good luck. Mine still appears to have been rebuilt by the way everything looks inside. The nose cone will come off after the rotor and bendix drive is removed. To remove the bendix spring there are 2 bolts that have a fastener ben tab and those bolts are 5/8 hex. Really easy to remove. Now the really fun part. Getting the drive end off the shaft. There is a shell just behind the gear. It has 4 tabs around it and what holds that togehter is a snap ring that has no ends on it. Look really closely for the ends. Press down on them with a wide blade screw driver and use a very small screw driver blade to wedge the ring out of the groove carefully. There are a couple of springs under that shell too. I took plenty of pics to insure I remove and replace these parts correctly. Now the final fastener is a threaded nut that has 4 slots machined into it. Not sure yet is this is right or left hand threads. Also finding a way to hold the rotor without damage when removing this last fastener is a good idea. Clamping the rotor ends in a bench vice wont do even with soft jaws. I'm thinking a soft jaw clamp that will fit around the rotor. May have some engineering to do later. Its nap time here now. Hot day here and no ac in shop. Hope that changes soon but we will see.
Hi,
 
Tom--thank you for this part number. I don't know the condition of my starter, but as of now it will be rebuilt with this improvement done!
 
--Tom
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
