Wyn, I think the way the cables are run and fixed in place on a sedan would be much the same on open cars. The armored cable wraps around the hinges and is held in place with clips and small screws. There are two locations on each hinge that have tapped holes. The armored cable is stripped back at each end where bullet connections are soldered on. When the tubular rubber covered connectors are fitted over the bullet connectors no live wiring is visible.On the trunk lid side the cables run down to the tail lights along the sides of the lid. The number plate light cable runs down one side and across to under the light housing. On the body side the cables are run in a loop at each side to allow the lid to swing open. When the trunk lining is fitted only the armored cables are visible.The second picture shows how I ran the wiring under the parcel shelf. Rather than glue the trunk lining directly over the cables I made a removable panel covered with the lining material which is fixed in place with screws to the wooden cleats.It allows easy access to the wiring and is virtually invisible when fitted.If you zoom in on the last picture you can see the small tapped holes in the hinges. 
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.


