HI David. The axle nut should be tightened to 300 ft-lbs. Since most of us don't have that big of a torque wrench I was once told to do it this way - get at least a 3' cheater on the end of your wrench and tighten it until it really squeels!
 
SAFETY WARNING - This is not the place to use cheap Harbor Freight or flea market 3/4" drive socket set or a crescent wrench. Get a good socket and breaker bar!
Earlier this week I grabbed my cheap socket and breaker bar (I was being lazy and thought the nut was loose) and broke the socket and was no where near the required torque! For this job I have a socket welded onto a 3' piece of 1 1/2" solid steel bar. yes it is very heavy but it has never bent or broke!
You might be able to rent a 3/4 drive torque wrench from a rental yard too. Calling costs nothing. Just a note about sockets for this particular job. But an impact socket. Check EBAY for the brand JH Williams or Proto. Williams is a great oil field tool used all the time in the steam generation plants.
 
 
Gary Parsons
I just checked ebay and found this easily.https://www.ebay.com/itm/Proto-07523-1-7-16-Standard-Impact-Socket-3-4-Drive-6-Point-MADE-IN-USA/362614728855?epid=1428533150&hash=item546d85a897:g:kq0AAOSwhElbDgbU
 
 
Gary Parsons
Hi Jim, What do you do when it SQUEELS and then turns easily!
CORDiallyMike
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
