

All 810 or 812 cooling systems are zero pressure. To the drivers side of the top radiator tank is a piacular raised bump. Thats the tank overflow and it runs down the drivers side of the radiator to the ground. I was advised to not fill the radiator to the top neck. That way when coolant expands it wont run out this tube. Just run the top tank half full and it will be fine. I got this information from Jim O Brien as I recall.
 
 
Gary Parsons

Thanks guys. Will check out the overflow as a possible way to put a 1 or 2 psi in to the system. I know not to use compressed air.
 
A.J.
AJ my radiator tanks were made by George Ehresman and supplied with a modern type cap. I think from memory the pressure is 4 psi. I will check it tomorrow.
Pressure testing the oil pump pressure relief valve I used an 18 volt Makita tyre pump. It has a digital read out in 0.5 psi steps. You could easily use one of these to check the cooling system.
George Van Nostrand has been having computer trouble and asked to post the attached picture.  It shows a novel design of fitting a pressure cap low down on the vent tube. He fitted a 2 lbs pressure cap but it blew the original tanks.
As mentioned earlier my radiator has a pair of tanks made by George Ehresman with the cap also supplied by George Ehresman. I checked the cap pressure which is stamped on the top. It is 4 lbs.
 
 
 
 
 

To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.





.JPG.7b0bf52fa7616cef5944239d0a64b96b.webp)