

THe question would be on step 4 when you do not have vacuum on the gage do you have 6 volts on the black wire?
 
The black wire is the signal from the selector switch on the column telling the solenoid to pick up and move the cross shift to the left (for 1st or reverse).
 
If you have 6V on the black wire (and terminal) then the problem is the solenoid not picking up.
 
If you do not have 6 volts on the black wire then your problem is up in the selector switch.

Once I got the replacement clutch switch from Stan installed all of the random power gremlins went away and I was able to smoothly test the connections.
 
So I created the following chart to help myself debug the wiring on interlock switch and the solenoids. Everything passes except for Neutral/Yellow where I have 6 volts and it should be zero.
 
However, watching the vacuum gauges, it looks pretty clear to me the issue is in the canister as I'm always getting the correct vacuum from the solonoids. I have ordered a new seal and diaphragm from Stan which will hopefully be waiting for me when I get back from Amelia.
 

I hate to be the bearer of bad news but your chart is not correct. Also the problem is the voltage on some wires changes during the shift process. I would not try and use the chart for trouble shooting as you will get in trouble.
 
Understood that things change during the shift process. The chart shows the voltage after the successful shift and the clutch still down. In my case, I need to move the shift arm to position manually. Do I have some of the voltages wrong or do you think it isn't a useful exercise?
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.

