

It appears this wheel was run with loose lug nuts so now the holes in the rim are bigger.Repairing it will take some TIG welding and machining to get it correct again. Knowing the centers is going to be very important.
 
 
Gary Parsons

The wheel bolts are an indication that the car has the original fragile cast wheel hubs. The flanges on these hubs flex and eventually cause the bolts to loosen. I suggest that you make enquires for replacement steel hubs. The steel hubs have studs and nuts. Don Wohlwend used to supply new rear steel hubs. I believe he sold that business to a guy in Canada. With the steel hubs you end up with a much safe driving car and virtually eliminate the wheel problems. I say virtually because it is a good idea to check the torque on the wheel nuts regularly.
I had my original cast hubs crack tested and was horrified to see they were full of cracks. The steel hubs are the only way to go for safe driving.

Awesome. When you say "Hub" is there a part behind the wheel drum? I assume I need to get the drum off to see it?
 
thanks.
 
A.J.

Peter Morgan gave me a call and explained what was going on here. I short term fix is that NAPA has lug bolts with a 7/8 head instead of the factory 3/4.
 
Peter Morgan gave me a call and explained what was going on here. I short term fix is that NAPA has lug bolts with a 7/8 head instead of the factory 3/4. 
 
Thats actually a great idea from Peter. I may try a couple of these lug nut bolts just to see how they fit.I doubt using these are going to drop us a few points in judging. How would any judge really know these were on a car.
 
 
Gary Parsons

Do you carry the breaker bar and 4 foot pipe in the car for when you have a flat? The eeeeccch sound is lug nut talk for STOP.
CORDiallyMike

I would never tighten a bolt with an impact wrench. You have no idea how much torque you are appling.
 
Cliff - with a 4' lever on the socket and guessing you are putting your weight of 100 to 150 lbs on the end of the lever which means you are putting between 400 and 600 ft-lbs of torque on the lug bolts. I don't have my charts handy but that is way too much torque. just my 2 cents.
I agree that 90 ft-lbs is the correct torque. I believe Josh Malks recommended this also. I remove the bolts with a gun, but tighten them by hand so as to not over tighten or damage anything.
Tim.
Every vintage car owner should own a torque wrench. Use it to install wheels then re-torque after driving. This is the routine on modern cars. 90 Ft lbs
is a good spec.

I have sent you a pm regarding a nice fix to the wheel/ brake drum connection.
Tim.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.

