


Randy, that took you almost 13 minutes to answer. I think you are slowing down.
This is related to my dad's 812 that he has owned for 55 years. I would guess that after a couple trips back and forth from Mass to Auburn among years of driving that it would be on the looser side at this point.
Has there ever been tech update with an auxiliary pump or modification to mitigate the problem?
Hi,
I'm not aware of any published modification, but I have to think that an electric pump could readily be fitted td do the job.
Alternatively, don't idle in neutral unless the clutch is pushed in.
--Tom
An easy solution is to cut a pieceof wood to theproper length that it fully depresses the clutch and fit's just inside the lower lip of
the lower dash. That way the transmission is not engaged and you can idle the engine as long as you want and nothing is turning in the transmission.
Using a block of wood to hold the clutch pushed in so we can idle for long times seems like it will add lots of wear on the throwout bearing. I learned that our throwout bearing is no longer available. So 2 questions.
Is our throwout bearing available.
Is doing the clutch in going to wear out any other pieces.
Interested in what others have to say on this. Its the only way we learn about these cars.
Whenever I need the engine to idle for a longer period I prop up the car so the front wheels are off the ground and set the car in gear.
 
I always wonder about the height of the suction pipe/port of the gearbox pump so I also prop up the rear just to be on the safe side.
Frank
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
