Oooops replace NOS with just Original ! 
Aris
My solution for lost gas and radiator caps. When I remove either I always put them on the drivers side seat! Can't tell you how many times I went to get in and there is the cap that I would have forgotten if it hadn't been on the seat!
CORDially Mike
Mike, the "Modern 810 812 Cords" were fitted with a chain attached to the fuel tank cap to save it from being lost.
The didn't get around to the radiator cap.
 
I carry a piece of leather which is hooked onto one of the smaller rubber pads and stuffed into the space around the filler pipe so that it can be extracted and the cap and chain placed on it to protect the paint when filling the tank.
 
 
 
Have a cap.
Need e-mail address
they had a small sash chain similar to these,https://www.1st-chainsupply.com/sash-chain-stainless-steel-8-x-100-ft-carton-made-in-usa-free-shipping/ there is one figure link at the ends.
 
Found the picture showing the cap, chain, spring clips and leather flap which stops the body being scratched.
Sorry I could not find the picture showing the leather flap.
 
[attachment=7848]Fuel Tank Cap Assembly.jpg[/attachment]
Finally found the right picture.
The chain is miniature sash chain size 12 and nickel plated or stainless steel
The chain is 6" long and can be purchased from
Wm A Kilian Hardware Co
Philadelphia
I made the clips. I used galvanized wire. The original would have been spring wire.
What is your email address ?
I'm having problems attaching pictures and printed sheets.
I will send you detailed information sheets on the Gas Cap Area
Thank you. Are the clips available someplace or did you make them? 
You can make them as Terry did... Or contact Carol at Cord parts in Wellington Kansas  or Doug from ACD parts in broken arrow Oklahoma. 
 
Gary Parsons
 
Thank you. Are the clips available someplace or did you make them? 
You can make them as Terry did... Or contact Carol at Cord parts in Wellington Kansas  or Doug from ACD parts in broken arrow Oklahoma. 
 
Gary Parsons
 
Thank you. Are the clips available someplace or did you make them? 
You can make them as Terry did... Or contact Carol at Cord parts in Wellington Kansas  or Doug from ACD parts in broken arrow Oklahoma. 
 
Gary Parsons
 
Thank you. Are the clips available someplace or did you make them? 
You can make them as Terry did... Or contact Carol at Cord parts in Wellington Kansas  or Doug from ACD parts in broken arrow Oklahoma. 
 
Gary Parsons
 
I'm still having trouble adding pictures. This is a trial run.
The clips are easy to make from galvanized wire, just don't yank on the cap as the wire is soft.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.


