Sounds like the flywheel has hot spots on it. You did not mention if the flywheel was removed and resurfaced along with the pressure plate. Please tell this forum if the flywheel was removed for resurfacing.
 
 
Gary Parsons
what do you mean by resurfacing the flywheel. isn't if just the metal surface of the flywheel? it should be bare metal for clutch to grab to I thought. 
 
Robert L Hauser 
As I already mentioned. The flywheel is always ground for a resurfacing during the clutch replacement. The surface most always has "spots" on it called hot spots. Those need to be ground out or you have a horrible mess with that surface grabbing as you mentioned. The flywheel MUST be removed for proper reconditioning. Its not expensive to grind the flywheel. But in our Cord cars you must remove so very much material to reach this area. The new club transmission repair book clearly describes how everything comes apart safely. I removed my engine n trans when I was in my very early 20's. I still have not set the engine and trans back in the car. Hope this guides you to a pleasant ending...
 
 
Gary Parsons
Hi Stanislav,
What specs were the clutch rebuilt to? The Cord uses a Long 10CF clutch. This clutch was also used in a Ford trucks and some other cars but was built to different spec.s. What is your email and I'll send you how to set up the clutch.
 
You also mention the pressure plate was straightened. That raises a lot of questions, How did it get warped to begin with? Was it ground back to proper straightness? Were all hard spots removed?
 
Have you checked the engine and transmission mounts? Also the CV joints. They would also cause similar problems.
Jim
The proper term for renewing the flywheel is called "resurfacing". If you use this term shops will know what you mean. The same should be done on the preasure plate along with replacing the springs and adjust the arms. All these procedures is best done by a shop that does clutches as a specialty. Is the clutch disc in backwards? There is a right and wrong way to install the disc!
CORDially MIke
Here is some info on the Cord clutch. This should help making sure it is set up properly.
 
I would also recommend Ft. Wayne Clutch.
CORDially Mike
My Cord shook alot when taking off
It turned out to be the Transmission mount bolts where loose
Much easier solution than clutch. Some times we luck out. Know if I could just figure out my 67 Corvette clutch noise!!!
CORDially Mike
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
