I have never heard of this idea. But am following this so I learn if its correct. I personally don't think its the way to do an over bore but???
 
 
Gary Parsons
I have never heard of overboring the top of the cylinder. I think Pat is right and that referes to ridge reaming to remove old pistons. Don't go overboard in reaming the ridge and remove more than is need to remove the old pistons!
CORDially Mike
I noticed your located in Kingwood NSW Austrailia. Terry Cockerell is located in Cooranbong NSW Australia. He is finishing up his Cord restoration. Sadly he used the EGGE machine shop pistons and they were not correct. The piston pins were 40 thousands too high up in the pistons so much that they contacted the heads. It took months of shipping back n forth plus all the fitting before he got a piston that was close. EGGE machine shop is in a new location and about 4 miles from my home. Hope Terry can help you out.
 
 
Gary Parsons
On a re-ring job , the need to remove the ridge is to prevent
the new top rings from hitting the ridge with the resulting damage.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
