Steve there are sheet metal strips that bridge the gaps between the wooden fixing pieces. We are on our way out to dinner right now. I will follow up with some pictures tomorrow.
Terry
Steve to make the job of installing the headlining more comfortable for your upholsterer may I suggest that you fit a temporary flat wooden floor to the body. Mine was made out of thick plywood and various wooden strips to keep it level.Also I had made and supplied new stainless steel rods that were stiched into the ribbing. 
Thanks Wyn and Terry for your pictures and comments.
I now know what I need to make and hope that in can make them.
I picked up a chrome plated brass 22 gauge x 1 1/2 sink drain tube" (about 38mm) with a 90 degree angle on the end . The radius about right for the straight pieces and and hopefully I can get the compound curve pieces from
where the tube starts its bend.
I will let you know if it works.
Terry, with regard to some of your suggestions, I did make new wires for the
headliner from the patterns that you were kind enough to send me Thank again. I tried using 1/8 in wire but felt that it was flexible for the job so I used 5/32" stainless which worked well.
I have not be able to get a definitive opinion at to weather the wire should be inside the piping or not but it is now a mute point because there is no way to re-bend the end of the wires without heating them to cherry red..
I wont tell if you don't.
I did make floorboards for the inside of the cat for the headliner and it really is a big help.
HOPE ALL YOU GUYS OUT THERE HAVE A HEALTHY HAPPY HOLLIDAY
STEVE KOLLER
Steve,
The wire should be inside the piping. Also if you glue the headliner to the metal pieces around the hinges you may have problems if you ever have to access the wiper motors. The only way to get to them is to pull the headling off above the windshield. The other option is to put an acces opening in the headliner. One way is to leave the access opeing open and glue the headliner around the opening. Then cover the wiper access plate with headliner material and screw the pate in. It is hidden behind the sun visors so you don't see them, but the judges usually see it.
Jim
Sorry guys for asking so many questions but I do have one more.
Does the wire-on that goes across the top of the windshield go down the side post as well or does it end at the top of the windshield and get tucked under the top of the windshield post trim.
I have pictures of it being done both ways and frankly it looks a lot cleaner ending at the top of the windshield but which is correct.
Thanks
Steve
Thanks Terry,
Not what I wanted to hear but it is what it is and it will be done.
The screws in the center windshield trim seem to be attached with oval head countersunk screws. Is that correct and do they use a countersunk washer under the head?
The devil is in the details.
Thanks
Steve
Oval head slot. Correct?
CORDially Mike
Thanks for all your help guys, I really appreciate it
Have a great Christmas and New Year
Steve
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.






.JPG.571e1f0f28c5d37306c79e5e665e0943.webp)




.jpg.ab79b7a8158cd39b3794372629704220.webp)
.jpg.75411ece22f1f082bcfc30527558f28a.webp)
.JPG.ee578fe122530cd9b3f5011113091a22.webp)
