HI RKF, I think I have them, I'll check tomorrow. Are you going to be in Auburn in a couple of weeks? If so I can bring them.
Jim
Jim
Thank form the reply
I won't be in Auburn
Can you tell me the price and I will send a check
My cell is 585-309-2588
Randy
Hi Jim
You wouldn't perhaps know of a drivers door regulator for a 1931 8 98A ????
 
regards
Rick
Hi Rick
Can you post a pic of the 1 you want or the 1 for the other side?
Pete
Thank you Pete for super fast reply !!!! I will open up the door tomorrow as it makes sense to either find a regulator or fix the missing teeth as that is what I think is my problem . I am an Auburn newbie down here in NZ and have recently taken over Curt Cutuis' 8 98 and am in the process of fixing little things that will make my compliance journey more straight forward.
regards
RIck
But Jim there are a number of parts common to both Auburns and Cords.
Rear spring shackles and door lock striker plates are just two examples that I am aware of.
Hi Again Have removed the regulator from my 1931 8 98 A Phaeton and pic is attached along with a close up of the problem cog where I think the slip has been happening . Fortunately I can turn the cog over and play with the alignment and probably get by . At worst could get it remade. The tiny primary gear which is operated by the handle spindle is also a bit marginal but should still do the job. If anyone has a good condition regulator then I would still be keen to obtain one and ship it to NZ where I live down under .Rick
Hi Rick
I looked and have 2 regulators but both are different from the 1 you are looking for and do not have interchangeable parts with yours. It might be easier and for sure quicker to make 1 by hand using a hacksaw, a file and a drill.
You might ask ACD Co in Broken Arrow OK an they had some but don't know for what models of Auburn or Cord.
Good luck
Pete
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.


