Your best bet is to find the specs for the 7/16 fine thread bolts because back when the Cord engine was made no torque wrenches were used or made . We have several engine rebuilders reading this and Stan Gilliand of Kansas has all the now used torque values.
 
 
Gary Parsons
You can purchase a book called Cord 810 812 Service Manual from the museum in Auburn which covers a lot of maintenance work on the cars.
In the books it states.
If the block threads are in perfect condition, 55 to 60 lb/ft cold, beginning at 45 then 50 and finally 55. Start engine , warm it up, let it cool then retorque heads.
If the threads are not so good, 45 to 50 lb/ft cold, beginning at 35, then follow the above procedure.
You must use Permatex Aviation Sealer on the threads to stop coolant leaks and also to prevent the bolts and block threads rusting together.
The attached diagram shows the bolt tightening pattern supplied with Higman heads with the deeper coolant jackets.
The procedure is the same for original heads.
I torque heads, let engine set for 24 hrs without starting it. Retorque the heads then start it etc. You will be surprised how much the torque relaxes in that 24 hrs. with out starting it.
CORDiallyMike
Interesting comments Mike, never checked that.
Actually these postings are in the wrong location. How can they be moved?
Thank you very much Terry, Garry and Mike for these useful pieces of information.
I will put the heads back today and we shall see....
Thanks again
Laurent
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.

