Hi Grant,
The original cam bearings were poured babbit. Today some people use bronze bearings. They have to be custom made. If you want a set let me know, I have to make a set for my engine so I can make two sets.
 
I have lot of extra engine parts (as well as other Cord Parts). What do you need? You can PM me or email me at ob7879@outlook.com
 
Jim
Jim, is this a new email address? Is old one cordman no good?
CORDiallyMike
Mike, Yes new email - the old one (cordman) is no longer. Also I no longer have a land line so you have to call my cell phone.
 
George, for the bronze bearings do you need to open up the clearances to account for the difference in expansion? or what?
The aaca has some good discussion on the pros and cons of babbit vs bronze
Wear caused from dirt is a concern. I have never tried to use bronze. I also have never had a babbit failure. Todays babbit has better properties then that of the 30's
My engine machinists has had excellent results using PaulÔÇÖs rod and bearing for pouring Babbitt for rods and cam bearings. There in Parkville, Mo.
6212 N.W. Bell Rd. 816-587-4747.
I also use Paul's. I no longer use insert bearings in non orig. insert bearing cars .
CORDiallyMike
There is more than one kind of babbit. some softer and some harder. Builder seem to have varying opinions as which is best.
CORDiallyMike
I use No.2 babbit which is also called diesel babbit. It is about 92% tin with copper and antimony making up the rest (I forget the percentages). The softer grades of babbit contain various percentages of lead.
Tom
The harder the babbit the more technique sensitive it is to solder. I had some hard babbit fail because it was improperly soldered. This failed babbit was NOT done by Paul's.
CORDiallyMike
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
