As already posted. Push in the clutch or drop the front bumper and remove the transmission sheet metal cover between the fenders. No amount of moving the steering column "shifter" will do anything. To make that work you need vacuum, engine running and press down on the clutch to initiate the shift. The clutch linkage has a switch connected to it that allows the shift to happen. You can place the shift lever in any position but it wont make a shift till the clutch is pressed down to the floor. There are 10 wires in the shift harness that sends electrical messages to 10 different items at mostly different times. It can be very complicated at times. Our club sells a very good booklet specifically about the transmission rebuilding and shifting. Its $10.00 and worth every penny of that.
 
 
Gary Parsons
Manually engaged the vacuum pump. IÔÇÖll speak with the mechanic tomorrow for a more formal explanation. Thanks for the ideas everyone.
 
size=500 https://i.imgur.com/vRd28To.jpg[/img]
https://i.imgur.com/RZoGtp1.jpg[/img]
https://i.imgur.com/xSwyrl8.jpg[/img]
https://i.imgur.com/OVAvBvy.jpg[/img]
 
The engine creates the vacuum needed for the trans to shift. You must start the engine. Have it running before any vacuum in made.
 
 
Gary Parsons.
It only takes a few minutes to remove the front bumper bar assembly which has two bolts holding it. Then the gearbox sheet metal cover can be removed . There are two bolts at the top and two bolts or screws with nuts at the bottom.
Check out the You Tube film showing 810 Cord gear changes.
The main vacuum cylinder sits on top of the gearbox and connects with the gear lever. All you then have to do is pull the lever on the cross shaft into the neutral position by hand.
When the film starts the gear lever is in the neutral position.
Appreciate all the responses. We did not want to ride the clutch for a mile. We also were aware that engine start was required, however we do not start vehicles that have been sitting this long. As with all things in life, there are multiple ways to skin the issue, and for the record we do own many ACD materials. With over 54 cars, it's more or less me just having really bad memory and free-associating solutions from other models for no apparent reason. Thank you for solving our brain-fog.
 
From our mechanic:
"I did not want to pull the front bumper or that front nose, so I stuck my hand back in there underneath the front nose piece and pulled (probably) 5-6" on the plunger rod that goes into the front of the vacuum canister. Then I slid the shifter mechanism over to one side and hit neutral (you'll know when you hit it). All in all, about 30 seconds once we stepped back and used our noggins."
 
size=1000 https://i.imgur.com/DEPB5wS.jpeg[/img]
 
Thank you again for the advice.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
