That screw in the circle is only to remove the lens so you can replace the bulb. The screws you have loosened are how you remove the complete bracket from the trunk. Remember you have a power wire that has to be disconnected too.
 
 
Gary Parsons
Is the licence bracket not held on by 3 screws?
Does not the small screw hold the bulb bracket in place?
Is the licence bracket not held on by 3 screws?
Does not the small screw not hold the bulb bracket in place?
 
You are correct Pete. I have been away from my car for some time and have forgotten specific things like this.Glad to be corrected by you as a knower more than I..... A relative novice in this restoration.
 
 
Gary Parsons
OK Guys, sorry for the confusion, culpa mea, I was not referring to the licence plate holder, but to the whole Tail Light HOUSING 🙁
 
My post should have been titled:
WHAT IS THE SCREW ON MY PICTURE USE FOR?
Followed by this description:
I would like to remove the TAG LIGHT HOUSING assembly so I can paint it, IF POSSIBLE without un-gluing the burlap carpet.
Does any one know what is the purpose of the SINGLE FLAT HEAD SLOTTED screw that I mark on the picture?
Is this screw maybe used to hold the housing onto another bracket underneath it?
P.S Hope this is less Greek to you now!!! 🙂
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.

