Hello Steve.
I have an original Beverly sedan interior. My seats both backs and seats are 2 inch wide pleats. The door panels are 1 1/2 inch wide. Some owner before me had seat covers installed so my seats are in really nice condition. I may not restore them but am in no hurry to make that division. I pictures are needed I can post some but.. I believe I have posted some a few years back. My ability to use the webs search engine is not vary good.
 
 
Gary Parsons
Thanks Gary,
I was leaning toward 2" pleats on the door panels as I have seen both 1 1/2" and 2" pleats in various pictures so it is good to know what was correct. 1 1/2" pleats it will be.
I don't need pictures but while I have your attention . I do have a few more questions.
1- Do you have arm rests on the rear quarter panels that are just aft of the back doors? Mine did but I don't think that it is correct? If there are no arm rest on that panel it would have been pleated. Do these pleats match the door pleats (11/2") or match the seats (2")
2- Do you have a pocket on the front right kick board under the dash?
3- I have what look to be the correct fittings for the robe strap that goes across the back of the front seat but they are made of plated cast pot metal which makes me feel that they are not original. I would think they should be plated brass. Do you have any idea?
Thanks for your help
Steve
My car did not have upholstery on the rear area you referred too. I know the armchair cars had something that looked like an armrest. I do have arm rests but no idea if they were on the front or back doors. Can't recall if I have 2 or 4 of them. I will look into this. I did not have front kick panels either. The front seat robe rack hardware was pot metal.
 
 
Gary Parsons
Steve, They had at least 3 or 4 different upholstery patterns for the Beverly. You need to do a bunch of research on your car to figure out what is correct. You might want to take a few photos and send them to Ron Irwin and ask him. Also in the 1973 Newsletters was a set of articles on the upholstery for a Custom Beverly which has some very good information.
Jim
Terry this is exactly what mine looks like.... Less the actual robe strap.
 
 
Gary Parsons
As expected Gary.
I forgot to mention that the robe strap is symmetrical.
Thanks Gary,
You should have two arm rests that would mount to the front doors only.
The rear seat is too far back to have an armrest on the rear doors.
I will try to post a picture of what I have.
Steve
Thanks Terry,
The end fitting is the same as the ones that I have although I don't have the buckles yet.
I would appreciate it if you could give me a good verbal description of how it was constructed. Please don't open it up to take pictures as I do not want you to damage it in any way.
Thanks
Steve
Thanks Jim,
I spoke with Ron but he was unable to help with the interior questions.
He did suggest that I contact Randy Ema, which I will do, who bought his Beverly which had an original interior when he bought it (now replaced).
I will try to find the info from the 73 news letter, but my car is not a custom so interiors are probably not the same.
Steve
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.

