Hello again Michael. I had a look at my wiring harnesses today and noted that the ends of the cables all have male bullet fittings. I could not find the plastic or rubber grommets that fit in the headlight bucket as seen in your picture but I removed them around 4 years ago and still have them .............. somewhere.
I do remember that they just popped out. Sorry I can't be more specific. You will have to clean up the area to see how the cables just pull out.
Sorry for asking again, but the connectors won┬┤t come off. Each of the single-connectors is moving freely for a few mm and is obviously spring loaded. With a lot of force the wire starts to break, but no way the connectors won┬┤t com free. The whole round connector moves with more effort and not spring loaded. but this moves only the insert-pipe for the wiring that comes from the wheel-side.
there must be a simple trick, who will find that out?
no ideas
Michael
thank you so much for organizing help in various ways!
am I right, that I should move the whole wiring with the inner metal housing to the inside of the front fender? the spring loaded connector is not disconnectable? perhaps it will be a possibility to cut the wire near the end an solder fresh wire on, then seal it with a shrinking hose.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.

