When you open the door there are two holes through which a tool can be pushed in to depress the sping clips which hold the handle assembly in place. I cannot locate a picture to show you the holes but they are in the door frame and either side of the handle shaft. Mine were mostly corroded away so I followed Pat Leahy's solution of using "C" shaped spring clips from a Chevrolet during the restoration.
What ever you do just be gentle and take your time.
Not exactly sure what you are asking for. Latch has many meanings on any Cord. Also door handles were the same on all cars be they convertibles or sedans. There are differences in lengths between sedan rear doors and front doors. I have not worked on the cab doors but think they are the same lengths as any sedan front doors are. But lets see what the forum has to say first. One last note. Every Cord leaving the factory had one key to lock up the car and it was only on the passenger side. A story comes with this for a good reason too.
 
 
Gary Parsons
The door handles and locks on cabriolets and phaetons are at a lower lever than those on sedans.
I would expect the mechanisms to be the same but maybe the handle spindles are longer as the door depth is greater than for the sedans. It is possible to dismantle the lock mechanism and make new parts which is what I had to do.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.



