Thank you for the good picture of the generator. It does appear to be mounted far to the passenger side as you noted. Our engines had three different generator mounting brackets. Yours appears to be an incorrect generator. Can you please post a clear picture or post the generator numbers here? Original generator for the 36 cars were the GAR4630 with the top mounted regulator. The 37 cars had the infamous GCO4804-A generator. Both are autolite types. The 4804 is the two brush where the 4630 is the adjustable three brush. Hope these facts are not confusing.
Am not sure where the chock wire is to be connected. My 37 car has the manual chock controlled from the dash center quadrant by a toggle as original design.
 
 
Gary Parsons
thank you Gary, 4804 is the type... perhaps it was changed with the bracket cause later cars do not have this curious cowl fill openings (right?).
I think for the choke I have to find a negative wire that is "hot" when the engine is running. Next step I will open the regulator housing and hope there is some writing in it. And perhaps I can find the connection to the startix where the cable insulation is rather broken.
 
Sadly the web site MAY be experiencing issues with posting pics yet again. Lets hope its repaired soon.
As for the choke power feed in the wire diagram, I feel it is correct. Even with the wire running to the startix its correct. Please remember the generatormust send voltage to the startix internal solenoid to keep the starter from engaging. Inside the startix we have two solenoids. If power is cut off to the running side solenoid then the start side solenoid engages so the starter can try to run the engine up till the generator is putting out enough voltage to change the power away from the starting side. This is one of the reasons some Cords will try to start when the rpm gets too low or the generator stops sending out voltage. It sounds complex and looks like it can't possibly work but it works very well.Surprising technology for 1936 cars. The startix actually was in several cars before the 36 or 37 Cords had it. Auburn's used is as did Pierce Arrows.
In the 3rd line of your reply I believe it should read
"remember the generator must send voltage-----"
Pete
You are correct Pete. I will fix it. Hope nobody gets confused both ways now looking at what I originally posted... and then "fixed"
 
 
Gary Parsons
I could not find a GCO4804 in my 1948 Auto-Lite Service Parts Catalog . The closest I can come is a GCO 4803A which is 37-39 Packard.
It shows CORD GAR4603-5 GBR4603-5 GBR4603-4 GCO4804A The GAR4603 will interchange with Auburn.
I could not find a GCO4804 in my 1948 Auto-Lite Service Parts Catalog . The closest I can come is a GCO 4803A which is 37-39 Packard.
It shows CORD GAR4603-5 GBR4603-5 GBR4603-4 GCO4804A The GAR4603 will interchange with Auburn.
the last you wrote is Cord... GCO 4804 A and this is it, but from a later 812 or so? is there a wiring plan for this version? any measuring for the correct clamp to fit it on the engine? I would realy like to awake my cowl fill for the oil (water seems impossible without the correct right thermostat housing and the end of the pipe being shortened behind the wrong ignition coil)
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.




