You should be able to get this from Auburn Cord Parts in Kansas. I did my Westchester recently and think the seal cross section would be the same. You peel the strip off the back and press it into the channel around the opening. I had to make a simple plastic flat edge too to make sure the rubber was pushed home. Fitting the boot lid was a challenge until I realised I could use my old drafting table as a temporary scaffold.
Gary as you know you have to be dedicated to work on a Cord. Never force or break anything ................. just ask for help .
If you had dropped the fuel tank you could access the rear side of the petrol cap door. There is a small screw holding the lock tab on the end of the lock cylinder. With a mirror and light you could have easily opened the door.
Putting the boot or trunk lid on is really a three person job to avoid scratches in fresh paint. The hydraulic drafting table was perfect for the job. One more point fitting the rubber seal starting at the top and in the centre work down each side and have the seam in the middle at the bottom.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.


