Stan rents the tool that makes it easier to bend this chrome.I bet they have instructions too.
J
· Mar 17, 2018
The best answer is very carefully. First get a couple of helpers to support the strips as you are installing them. I start by marking the center of the strip with a piece of tape. I then slide the appropriate number of clips on each side and space them out to the approximate locations. I then start at the front of the fence (center of the strip) and slowly work down, lining up several clips with the holes at a time and pushing one in at a time. It's easy to work down the side. There is a tool to make the bend at the rear of the fence but you can do this carefully by hand. Then work down the other side of the fence.
M
· Mar 21, 2018
Thanks Jim.
T
· Mar 21, 2018
I am yet to fit new grill trim to my Cord which I am currently restoring however for best results the trim is not just pulled around the louvres and fixed with the spring clips, it is slightly curved by hand to sit away from the louvres so that it will sit firmly in place when clipped into final position. I found this to be the case while removing the original trim. I will check it in the garage and post a sketch tomorrow when I have time.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.