Hi Jack, I know little about 810-12 Cords but if you are talking about wheel bearings Timken suggests having .002 end clearance when adjusted correctly. This is usually accomplished by tightening the nut tight and backing it off and tightening it by hand only. I have used washer shims if I thought the end clearance was too tight or loose at the cotter pin hole. Looking forward to seeing you at Auburn.
CORDiallyMike
Thanks to North Carolinian uconn_1965 , Californian 1748S and Michigander mikespeed35. In the last twenty four hours
I purchased a 1" less thick Grade 8 flat washer and tightened the spindle nut with a 16" SK breaker basr. The nut is tight, the cotter pin can pass from 8 to 2 on the clockface and the brake drum/U-joint/drive shaft assembly turns readily. Is there any safety or reliability problem created by the thinner washer substitution??? The bore of the new washer is 1 1/8" vs 1" on the original so the washer is not fully concentric with the axis of the spindle. However, the face of the nut is in full contact with the washer. Thanks for your further comments. Jack Richards
#1080 in Missouri.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
