I have a 4" structural channel frame I made that bolts to the subframe. It consists of two separate channels that bolt to the subframe, then go straight forward for about two feet and then taper inward till they nearly touch each other. The front end has an upper and lower plates joining the channels (bolted). The upper plate has a 2" tube welded onto it with a standard 2" boat coupler attaches to it. I also included two sets of safety chains. I have used this many times trailering a Cord body with rear axle and rear tires installed. I utilize it also for moving around a couple of Cord bodies in my shop that are in the same state as you have listed. A magnetic base brake and stop light assembly can be purchased at Harbor Freight to complete your trailering needs. If you are anywhere close to Auburn, Indiana you can borrow this from me. If you want to make one, I can take a picture of it.