After checking everything for correct adjustment and removing any wear or slop from things like the centre steering arm pivot the next thing to do is balance the brake drums and wheels separately. I wrote an article on balancing my brake drums in the Cord Forum. Separately is best as you will move wheels around from time to time. A front end alignment using the Factory Specs must be done. Then after all the above has been done you need to look at the rear springs as they usually sag which lowers the rear end too much and this changes the front end geometry.
The rear springs are often overlooked.
I had a shimmy on my Marmon 16 above 60MPH and it turned out to be bad front shocks. Just a thought.
CORDiallyMike
The double ball bearing from the steering W bellcrank shows up on EBay occasionally. Goes for about $80 when it's there. It was also used in GM applications.
 
It was also available from OLCAR Bearing Co, Southern Pines, NC, a few years ago; might still be. It is new Departure 900916.
 
--Tom
You may just want to jack the car up and see how true the tires run via hand spinning - I have seen some really oval and square tires out there (and often right out of the wrapper).
 
We are very fortunate in Cincinnati to have a race guy who does not mind working on 30's cars and has a mind for getting geometry right. Surprisingly, he had a program for a 1935 Auburn via Hunter and we just drove it onto the rack, hooked up all the gauges, and adjusted the car - fabulous on the road, but only as good as the quality of its tires (which leave something to be desired).
There was a article about shimmy in one of the older newsletters.
Couple of things I remember are to check front wings for loose nuts and bolts fit of the doors.
 
Frank
Found it .
Tech talk in newsletter no 4 1992
Stan Gilliland wrote a detailed article on how to stop the shimmy in one of his parts catalogues. As I had previously stated rear springs sag with time and people tend to prefer cars that are lowered at the back. This is wrong for a Cord there was about a 2" gap between the tyres and the rear fender arch when they were new. Check the attached picture which was taken in 1936 with the original owner of my Cord. Allowing for the slight slope where the car was parked at the time. The rear end must be sitting up.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.

