You can check for vacuum by switching on the wipers.Try the wipers before the engine has warmed up. When you suspect a vacuum leak later on, try the wipers again. If they work as before, look elsewhere for your problem.
That is, if your wipers work at all. 😉
I suspect a bad contact in the cross shifter switch. I use a modern switch made by Stan. I could not get 2nd or 3rd. Opened up the switch, and a small spring for the 2nd/3rd contact was bent.
If the selector is moving in the proper H pattern on top of the trans, then your vacuum should be good.
I would not open the can of worms called the shifter on the steering column. You can still check electrical signals coming out of the shifter by opening the wiring coming out of the firewall. Push a voltage tester sharp end into whatever color wire you want to check at that spot with the other end on the contact at the cross shifter. If the light comes on, you've got good voltage down to the cross shifter switch.
Tim.
So after a couple of shifts the contacts warm up due to the dirt and the resistance goes up.
Something to remember.
Thanks for sharing the solution.
Frank
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
