Hi Andy, I posted instructions on how to make a Cord 810-12 engine into a full flowing filter system. I should be under Cord 810-12 somewhere. Maybe this would help. If you can't
find it let me know and I will bring a copy Thur. and give it to Jon Bill. Not my instruction mind you but Lee Richardson's.
Cordially Mike
I would suggest that maybe you should replace the original oil pump in the pan with an inline electric fuel pump. I would make an 3/16" plate adapter with a 5/16" barb fitting that would attach where the original oil pump mounts. I would install the pump in the pan and possible wire it through the oil level sender location. I have built an adapter like this to test an engine that I have rebuilt by putting the original oil pump in a 5 gallon bucket of oil, and I use an 1/2" electric drill to run the pump. When connected up, I can see the oil coming out of the main and rod bearings as well as all the camshaft assembly. I found this quite useful in determining any excess tolerances in the drive train. You have to have a big pan to catch the oil also when the pan is off.
Mike's suggestion is also a good one to remotely mount a pump. I have three engines with this coversion.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
