I guess its as already asked. What exactly are you looking to have done to the trans and engine? Most any machine shop that overhauls any type of engine can bore the cylinders. The valves can be ground easily too but the cam bearings are difficult to find and there are 5 of them. All different sizes too. Most every valve piece is available from Cord Parts, Wellington Kansas or the factory in Oklahoma. All the rod and crank bearings are a poured babbit type bearing or you can have some machine work done to them and inserts like any other engine can be used. If the heads are original they should be replaced for the new type that have extra coolant capacity in them. Doing that requires a different set of head bolts too. This club sells a very good book on how to rebuild, take out or install the transmission. Its called Cord Transmission Manual and its by a member named A. S. Ayers. He collected lots of information from many different owners so its well read and a thing to have before you open up the trans. I have used it lots taking apart my trans and differential gears. Without this manual I would be lost.