Maybe a stupid question but what is the purpose of the "restricted" fitting?
Cordially Mike
I can tell you from personal experience that a 1963 Corvette doesn't have a restrictor in the line. I put about a quart of oil on the front carpet of my 63 after removing the dash and not hooking up the oil line. That was many years ago. Hope I'm smarter now!
Cordially Mike
Sounds pretty good. I tucked my gauge against the right side of the steering column mount, and so the column pretty much blocks it from view when looking in the drivers window. Not real obvious from the other side either. I have seen them hung right below the glove box and I don't care for that. However, I don't want it in my glove box either. To each his own. 😁
I am familiar with the story in Josh's book about the run to LA in the prototype that didn't have a transmission pump. Yes, it went a long way before total failure - however excessive wear was occurring the whole time up to the ultimate failure. I am interested in catching a problem at the beginning.
Hi all,
I have not one but two pressure sensors on the transmission oil line. The first prevents the transmission from shifting into first or reverse unless there is no pressure in the oil line (car is stopped or almost stopped). This uses a "normally closed" pressure sensor wired inline with the vacuum solenoid that controls the first-reverse position on the vacuum shifter (Josh Malks had suggested this safety feature). I have another sensor (also normally closed) that operates a small 6v red led light mounted in the space between the steering column and dash trim that is immediately visible when on and unobtrusive when off. To keep it from lighting up every time I stop, I have an additional clutch switch (wired in series) that keeps it off when the clutch is depressed. I kind of like "idiot" lights for a function like this, I don't have to keep checking a gauge.
Jack
Thanks again to Jack for his post regarding this useful modification and to Tom for following through with the referenced article when I dropped the ball. Tom is correct, for those with the newsletter disc, the article by Lee Richardson with diagram and photos is found in Newsletter 5 for 1998 on page 11.
I plan to spend some dreary afternoon this winter installing a switch on my car.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
