Congratulations on figuring out the headlight adjustment. Would you document what you figured out?
Thanks!
First there are 2 screws that are stop adjustments, one for how far the door opens, the other for how far it closes. The one for how far it closes is threaded through a bell crank arm and can be seen lying on your back with the headlight access cover removed, and looking towards the outboard side. If working on the passenger side, turn the wheels all the way to the left, and vice versa to be able to see the stop screw - the inspection cover could be bigger, lol. Obviously, if the headlight is closing slightly too far or not far enough, it will not be aligned with the fender.
Next, loosen , or if required, remove the hex head bolts underneath the fender that secure the headlight assembly to the fender. This will allow the whole works to be moved left and right and up and down. Some of the holes in the fender may need to be elongated slightly one way or the other to get the assembly where you want it. Note that adjacent to the hex bolts mentioned, there is a bolt stem with a screwdriver slot in the tip with a hex nut on it. This is the end of the long adjustment screw that controls how far the headlight bucket OPENS. ( You will see the head end of this long screw when you are looking inside the inspection hole for the stop screw that controls how far the headlight door closes.) The nut needs to be loosened away from the bottom of the fender when loosening the other bolts, but hold the stem with a screwdriver if you don't want your open adjustment to change. If you determine that the hole where this screw stem comes through the fender also needs elongating, then the screw will have to be backed out from the headlight assembly side and readjusted later. If after doing all the above, the headlight door is still "sunk" in relation to the fender, you will have to remove the whole assembly and grind the mounting bosses where they contact the fender, thus raising the assembly in the opening. In the worst case, where poor body work may have been done previously, the fender may have to be worked and /or the headlight door built up. The adjustments described made my fit much better.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
