Pete,what is your idling speed just after starting? Try blipping the throttle before depressing the clutch(shifting into gear or not should not make a difference). If this helps the generator rpm is to low to switch the startix. Try raising the idle speed by a bit.
Hopes this helps.
If the starter motor starts when you shift instead of when you depress the clutch, find out the voltage at the startix while you shift. If you have a wiring problem(short/bad ground) somewhere in the shifting harness/solenoids this may lower the system voltage enough to let the startix switch over to starting mode.
The first thing to check is the wire from the Startix back to the generator. After it starts it must have 6 volts going from the generator to statix to drop out the startix function. If it has power then the drop out relay in the Startix is not working. If this relay appears to be malfunctioning, disconnect the top small leads (power from clutch switch and the other is from generator) and put 6 volts to the terminal that was used for the genearator input, you should hear a click sound. A check of the battery and sarter terminals should show continuity when this relay is de-energized, and open when it is energized. Of course the simpliest way is to replace the unit with a known "good" unit.
 
 
The other thing I would check would be the clutch switch. Make that the separate input terminal on clutch switch is connected to input power. The two output terminals should go to the shifter and the other to the Startix. If this is OK, I would then remove the wire on the clutch switch that goes to the shifter and sede how it reacts.
Gents- Thanks for your responses! You all were right- I had a break in the wire from he generator to the Startix "gen" fitting. The car is up on jack stands so I can check the shifting without starving the generator from its oil pump, so now its "road time" to check the brakes, clutch throwout bearing setting, etc.
 
This communication ability of the ACD website is very helpful, especially with so many knowledgeable members who participate!
 
Pete
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
