My experience is that the condenser is a great part to replace first.
 
Sidenote: I have pulled new condensers out of the box (5 minutes after picking them up at the Auto Parts store) to have them equally be bad.
 
Fortunately, a condenser is probably the cheapest part you will install in the mechanical system of your car.
 
And, NAPA has Auburn and Cord still in their books.
 
Thereafter, I would look to the coil - my beautiful Auto-lite authentic coil was nothing but trouble.
 
And after that I would look to switch and electrical connections.
 
By the way, I recently had a friend experience ignition problems to find out the bearing in the distributor was bad - and what was worse was they did not catch it quick enough and destroyed a very rare and expensive rotor and cap)
I seem to have located the problem that was causing my Cord to run rough. The distributor is worn enough that upon acceleration the point gap becomes too wide. By decreasing the gap it now runs much better.
 
Any suggestions as to who might be able to rebuild my distributor?
Henry Portz comes to mind. There are a couple of distributers offered on ebay and one is a new old stock never been used. Its not a bolt in fix for our engines but it has all the parts you need to rebuild yours.
Here is a fair price for a useable part.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
