If your gas gauge is not a liquid filled glass tube it is not original.
CORDially Mike
I gave the wrong information. I was thinking we wre discussing a 851 Auburn. I know little about 810-12 Cords. Sorry for the confusion.
CORDially Mike
There is not a resistor in line. All this is handled with the Gas/Oil gauge. There is resistor wire winding in the sending unit the further the arm moves along the wire wound the less voltage goes back to the gauge. Therefore decreasing current flow or increasing electric flow depends on amount of fuel in tank.You can bench check this gas sending unit with ohm meter.
 
I got it, I?ll bench test it for smooth ohm reading. Thanks Ethan!
It may be beneficial to note that when checking a fuel tank level sending unit (or oil level sender) to use an analog ohm meter, rather than a digital, to better notice breaks in continuity. In some circumstances, the rheostatic winding and contact can become oxidized, for which a good cleaning solves the issue, but often they are damaged and require replacement.
 
OK, had time to work on this and now the fluctuating needle problem is resolved. Just as indicated above, the rheostatic winding needed a good cleaning, and now the needle is steady all the time.
 
The only remaining issue is the accuracy of the Empty-Full indication on the dash gauge. When Empty or Full, the needle does not go all the way to E and F. (sorry, but I have not managed to add pictures here...)
 
My guess is that the sender unit is not the original and it's ohm resistance does not match the resistance of my original dash gauge, but it's good enough for now anyway.
Aris, I've always wondered about the accuracy of these gauges.
Maybe someone in the know can .......
My view is that given the choice I'd prefer the gauge to be accurate towards empty instead of towards full.
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
