Brad; The Cord uses the Gemmer model 330 with stradle mounted bearing. It is
similar to Chrysler Airflow.. Remove the 4 screws on the
worm cover to take apart. Find an old Motors Manual to repair and adjust. See also Cord service bulleton 810 no. 22.
Thanks, George.
 
I assume that when I take the cover off I'll find a nut holding the worm on the steering shaft? Anyway I'll go ahead and take the cover off and hopefully it will be obvious how to proceed.
 
Brad
Thanks, Mario. I knew it was a possibility that the worm was pressed on, but I guess I was still hoping for an easier solution. I don't expect to have to trouble you for pictures, but I appreciate the offer.
 
Brad
I had the problem that with my custom beverly project, the Steeringcollumn was of a Westchester and therefore to short, what i did was, i organized a original Custom Beverly steeringjackettube ( which is longer, thanks Henry for instruction and tube ) cut the steering collumn and filled in the additional length with a joint sleeve piece that is fitting snuggly and secured by two setscrews on each end, now why should that interest you ? This way i can extract the Steeringbox without taking of the Steering Wheel, collumn and exhaustcollector.
This solution will not work for you now, but would next time, if you ever need to work on it. Not that i urge you towards that idea to perform on your 'box but is surley a benefit from my extension that was needed. By the way, i did not weld, because welding is allways a problem to get it absolutley straight without turning on a lathe. Best regards Philipp
Perhaps these links would be of use...
 
[url:2v8q7e2a]http://restorecarsclassifieds.com/wiki/show_pdf.pdf?n=11083[/url:2v8q7e2a]
[url:2v8q7e2a]http://restorecarsclassifieds.com/wiki/show_pdf.pdf?n=11084[/url:2v8q7e2a]
[url:2v8q7e2a]http://restorecarsclassifieds.com/wiki/show_pdf.pdf?n=11085[/url:2v8q7e2a]
[url:2v8q7e2a]http://restorecarsclassifieds.com/wiki/show_pdf.pdf?n=11086[/url:2v8q7e2a]
[url:2v8q7e2a]http://restorecarsclassifieds.com/wiki/show_pdf.pdf?n=11087[/url:2v8q7e2a]
[url:2v8q7e2a]http://restorecarsclassifieds.com/wiki/show_pdf.pdf?n=11088[/url:2v8q7e2a]
[url:2v8q7e2a]http://restorecarsclassifieds.com/wiki/show_pdf.pdf?n=11089[/url:2v8q7e2a]
 
The information is not specific to Cord, but does list the Gemmer model 330.
Hi Mario,
This is Aris Loumidis from Greece, I have sent you a PM about the steering box problem I also have on my 810 Phaeton, I would appreciate the pictures if you still have them!
Thanks Ahead,
Aris
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
