I was just on Henrys parts page today. As you said, they are out of stock. You can look at ACD parts on Broken Arrow Oklahoma site. They are listing about 136 items on ebay at this time and one of them is a rebuilt water pump for $1350.00. It sounds high and it's been on the listing for several weeks. Personally, I feel $800.00 is a more reasonable price but that's just me.
 
 
Gary Parsons
Hi Pat,I bought two of HenryÔÇÖs kits a couple of years ago when my WestchesterÔÇÖs pump started leaking. ┬áI installed one in the Westchester and am saving the second for my Phaeton should it be needed. ┬áThe instructions provided with the kit may be helpful to you so I am attaching them. ┬áI am not sure how bad your back cover is but if it is all in one piece you may be able to salvage it with the bronze repair bushing that Henry made and sold. ┬áAccording to the web page it looks like there are still some in stock. ┬áThe bronze bushing can be used to fix both the front housing and the back cover. ┬áOnce I got the kits I also did some digging into information about the seals and bushings that came in the kit, it turns out that they are not anything special. ┬áI was able to buy quite a few of both the seals and bearings on EBay, following is the information:Seal: ┬áSpa pump seal for 3/4ÔÇØ shaft, part number PS-201. Cost about $9 eachBearing: ┬áSKF 6202/2RS/C3. ┬áCost about $11 each.When I installed the kit in my Westchester I elected to not use the bronze repair bushing for the front cover as I did not want to deal with getting a machine shop to do the front cover modification. ┬áI was able to use the new seals in the kit to seal against the cast surface once I had cleaned it up and lapped the seal to the cover as Henry describes in the instructions. ┬áIt took me three tries of assembling the pump before I got it to not leak. ┬áHopefully I can help save you some of that effort.Feel free to give me a call if you have any questions.CORDially,Bill. 707 494 0715
Thank you Bill for the information, it is very helpful. Hopefully, I might come across a complete kit. The cover is in one piece but very thin and would almost be impossible to weld. Also, I have no idea how worn it is where the impeller sits but would imagine quite worn.
Thanks
Pat
Hi Pat,
 
Having not seen your back cover I cannot say for sure but I would not think that welding would be required. ┬áI would think that brazing or JB Weld could suffice. ┬áYou will note in HenryÔÇÖs instructions that the cover gets machined to accept the bronze bushing which is then lightly pressed in and held with Loctite. Clearly if your cover has insufficient metal remaining none of these approaches will work.
 
Good luck finding the Portz kit, they are very nice and the replacement back cover seal is clever and no fuss.  If you are not successful in finding someone that will part with a Portz kit let me know and I can see if I have a back cover and impeller that are more serviceable than yours.
 
Best regards,
Bill
Bill, I will keep you posted, but if you have time to look for a cover that would be great, trying to keep all of my options open.
Thanks
Pat
Hi Pat,
 
I can send you an email with pictures of the extra back cover and impeller that I have.  Please let me know your email address.or send a note to mine and I will respond.  My email address is Rileypu29@yahoo.com
 
Bill.
707 494 0715
Email sent
Thanks
Pat
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
