I do not want to put a damper on your sale, however discussing hard chrome plating of rocker arm shafts with specialists at Heat Treatment Australia located in Sydney it was pointed out that needle rollers should not be used on hard chrome plated surfaces as the surface would eventually break up. Bushes would be the best way to go as they would not cause any surface failure.
Please note Heat Treatment Australia has a branch in Santa Fe Springs, California and can be called on 562 321 2100
 
Re-reading your original posting I realised you had noted "lower bushings" consequently I apologised for jumping to the wrong conclusion. The information however is still valid.
Regards,
Terry Cockerell
Thanks George and Terry for making sure everyone is on the same page with this needed information. I live probably 1 1/2 to 2 miles from the Santa Fe Springs location. I may use them for my shafts. My rockers were upgraded to needle roller rockers way back in 1961. But the shafts were not hard chromed and are ever so slightly worn.
 
 
Gary Parsons
To join in the conversation, you must be a club member.
You’re welcome to read and like every post. Members can reply and start topics of their own.
